![]() Elo does not warrant or support this information and cannot be held liable for accidental or intentional misuse of this information. This information is intended as development information for use by trained professionals, and is not a procedure or statement of work.The 2216, 2700, 27 controllers run 9600 baud ONLY – the baud rate cannot be changed. This document applies only to Elo AccuTouch, IntelliTouch and Surface Capacitive SmartSet touch controllers that have a serial interface.Failure to send the Save command will result in all changes being lost when power is removed from the controller. Sending commands changes the present configuration of the controller, but the changes are only permanently saved in the controller when the Save command is sent. Note that the Save_to_NVRAM command must be sent after all other commands have been sent. Hyper Terminal, a relatively simple, widely available Windows accessory program, can be used to send the commands.Ī set of ASCII text command files is available to perform setup, older data format emulations and other changes that are most commonly requested. Other changes can also be made, such as reversing one or both of the touch axes. Doing so will change the format of the touch data. Modern controllers can be programmed through a serial connection to a PC's RS232 serial interface (COM port) by sending simple alpha-numeric command strings. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |